Main Controller for X-10 connection and control from the Visonic Powermax Panel.

To turn a light on or off, press the rocker switch for a moment either upwards or downwards. To brighten or dim press and hold the button either upwards or downwards. When the unit is turned off from a dimmed position, it will always return to full brightness the next time you turn it on.

Responds to direct X10 commands, and also to All Units On/Off

Provides ON and OFF functions and responds to ALL-LIGHTS-ON and ALL-UNITS-OFF X-10 commands.

The X10 House Code and Address is programmed via an X10 transmitter.

Insert a standard light bulb (up to 150W) into the LM15.

DO NOT use with fluorescent lamps or low energy lamps.

Turn the lamp switch on if appropriate.

Set any X-10 controller to the House Code and Unit Code you want want the LM15 to respond to.

Press the ON button (corresponding to the Unit Code you want the LM15 to respond to) on the X-10 controller three times, at about one second intervals. On the third press, the lamp will turn on to signifying that the code has been learnt.

To change the code that the LM15 responds to, turn off the power to the unit, turn it back on and repeat the previous step within 30 seconds after applying power.

Please note the this module is NOT dimmable. It functions as On/Off only.

This module uses isolated contacts to control such low voltage devices as sprinkler systems, curtain controls, garage door openers, and garden lighting. It can be set for momentary or sustained contact closure, and has a built in chime.

Features: Rated a 5 amps at 24v DC